KUAFU Front Seat Back & Seat Bottom Cover Compatible with 1993-2019 Kawasaki Mule 2500 2510 3000 3010 4000 4010 Bench Seat Cover

Good quality seat material. Marched the original perfectly on a mule 4010 4×4. I’ve been. Restoring this one and after new plugs, iinjectors, drive belt and blow torching the green plastic then compounding and buffing it, a new seat was needed. Ours had good cushion but a tear on the drivers side made it look bad. This cover has the corners all sewn together so you just have to un bolt the old cushion (4 bolts) then place it right over the old one if you want. I did ours like that. Flip it over and staple it on just above the line of pre existing staples for the original one. I did a couple on each side while pulling slightly to take wrinkles out and then a couple staples front and back checked the placement by turning it over then did the corners and filled in all around with staples. I used arrow 50 staples on ours. I had to get a stronger staple gun though. At first they just barely stuck into the hard plastic so I got a heavy duty one and that worked better. I recommend holding a piece of wood or metal along the outside edge of where you’re stapling. Push the stapler hard against the plastic with a piece of wood or metal on the outer edge so the sandwich of your metal or wood piece is against the outside edge of the seat pressing hard against the old cover and the plastic base the old cover is stapled to, then your staple gun. If it isn’t tight sandwiched the staples won’t go in very deep so press hard and do a line of them the same way the old ones were done just a little more towards the bottom edge of the plastic base the old cover is stapled to. I used a cheap clothing steamer to remove wrincles from packaging then bolted it back on. Looks like new. Good quality material stretches well just do t go crazy pulling on it. Like an inch or two to tighten it will do fine.Have fun!